4.9 (690) In stock
Looking for someone who has experienced this before. When I am printing parts with a large surface area/bottom layer, I keep having this issue. Smaller parts print great. It just seems when it extrudes long lines along the bed right next to each other it has issues. It’s hard to say that is a bed adhesion problem if you were to watch it closely as it went. It’s not that each line isn’t sticking to the bed, but it looks like as the next line comes back beside it tends to peel up the previous lin
Any idea what causes this pilling and mess on the first layer
cdn./wp-content/uploads/firstlayer
First layer issue – Assembly and first prints troubleshooting
prusa i3 - First layer looks weird and print fails - 3D Printing
V1 Engineering Inc -V1E.com
First Layer Issues : r/FixMyPrint
First layer issues – Assembly and first prints troubleshooting
First Print - Troubleshooting - V1 Engineering Forum
Large ASA prints warping - Bambu Filament and Accesories - Bambu
First Print - Troubleshooting - V1 Engineering Forum
Issues with first layer – Assembly and first prints
🔥 The definitive guide to solving 3D printing problems by Bitfab